Media Library / Images

Oasis FV103 Fill Valve with extension, CNG dispenser

Production plastic parts

Injection Molding

ERV with FSH:

Flame protection cover (open)

ELAPHARM Type EPH

electrically isolating 'I', with blue cover, to EN 16820, Type A. FDA conform, homogeneous elastomer hose construction with smooth, white PTFE liner. Clamp fittings, lining flared (free of dead spaces).

Dispenser picture to distinguish the three different kinds of Safety Breaks

Hose Break, Pump Break, Nozzle Break

Underwing refuelling, HD-C

Aircraft dispenser, pit

Elaflex hose assemblies, nozzles and Rubber Expansion Joints for the chemical industry

GasGuard GG11R

The GasGuard GG11 Back-Check Valve (GG11R: with additional release screw) should be standard equipment for any LPGas road tanker operator. It is used in conjunction with LPGas bulk refueling nozzles to contain leaks at storage tank fill points. If the fill point proves to be leaking when removing the nozzle it can be left on the tank until corrective action is taken. The driver can move to the next fill point without delay.

V 16-3/4" NPT

Male ferrule hose coupling EN 14424, reusable. Slimline 19 hose, black.

Bunker boat: TW hose assemblies, TW couplings

Cargo loading of a tanker with petroleum based products; FHD hose assembly with new longitudinal stripe to avoid torsion

Picture courtesy of Macoil International, Gibraltar

Oasis BV708, 1" ball valve / isolation valve, CNG fill post for trailer loading with HC200 Quick Coupler

ELAFLEX Hamburg

Assembling Spannfix hose clamps

ERV-W 80.16 ZS 2

White Band Rubber Expansion Joint with "ZS" limiter (tie rods with outer limitation in rubber bushings)

ELAFLEX Tanktechnik, Production Plettenberg / Germany

Sand casting

DEC – Dry Evotek Coupling

Dry disconnect coupling for the chemical industry

M 21-1" NR cr

Female ferrule hose coupling EN 14424, factory assembled, non-reattacheable. Slimline 21 hose, blue.

FF-St 80 SSE

Fixed flange hose tail for assembling with Spannfix or Spannloc. Material: stainless steel with universally resistant PFA coating (red)

HD-C LT, Low Temperature

LT (Low Temperature) types of our aircraft refuelling hoses are suitable for use in especially cold regions - high flexibility.

ERV-W 80.16

WHITE BAND Rubber Expansion Joint for foodstuffs, also containing oil and fat. Liner corresponds to Recommendation XXI of BfR and FDA-21CFR 177.2600. Not approved for drinking water. Temperature range (depending on medium) - 20° C up to + 90° C, temporarily up to 100° C. Electrically non-conductive.

ZVF 50 JET overwing refuelling

with HD-C hose assembly

MX 63-21/2" Ms

Female coupling for hoses, brass, with Spannfix clamp

ERV-W 80.16 SS TA

White Band Rubber Expansion Joint with "TA" PTFE lining

ELAFLEX Tanktechnik, Production Plettenberg / Germany

Assembling hall, meterial logistics

Slimline 16 red

Quality petrol pump hose for gasoline and diesel fuels. Also suitable for fuels with ethanol content up to E 85 and Biodiesel up to B 30 (BIO Type up to B 100). Meets weights and measures regulations, see overleaf. Cold flexible down to - 30° C / - 22° F (LT-type down to - 40° C / - 40° F). Corresponds to EN 1360.

Hose trolleys, HD 100 C

Type HD-C, aviation hose, Aljac bonding reel und Lanyard reel

DN 2" Ms

Double nipple brass

L.P. Gas rail tanker

loading and unloading with DGC Dry Gas Couplings; Use of adapters with ACME thread

SC 50 SS

Spannloc clamps, stainless steel

HB hot bitumen hose - loading road tanker